Enable multitouch function for HP MultiTouch Monitor

Follow these steps if multitouch doesn't work in Windows 7 O/S.

Disable UAC (temporarily):
1) Windows-R to open the “Run” dialog box.
2) Type “msconfig” and press enter.
3) Click the “Tools” tab. Click “Change UAC Settings” and click “Launch”.
4) Make a note of the current setting.
5) Slide the slider to the bottom (“Never Notify”).
6) Click OK to save the setting and OK again to close Msconfig.
7) Reboot the PC.

Install the Inexio driver package:
1) Visit [You must be registered and logged in to see this link.]
2) Select “Download” / “Driver & SDK”
3) Download the Windows 7 package appropriate for your installation (either 32- or 64- bit)
4) Extract the downloaded file to your desktop, and then run setup.exe
5) The installer will ask you to unplug the device. Unplug it. Reboot when prompted.
6) Wait until you are logged in to the Windows desktop after rebooting, and the system completes loading.
7) Connect the USB cable to the PC and allow the device to be detected.

Configure the Inexio driver:
1) Launch the “nxTCon” icon left on the desktop by the Inexio installer.
2) Select the Mulipoint Touch tab, and check the box “enable gesture action”.
3) Select the Setup tab, and check the Touch Action / Drawing Mode radio button.
4) Click OK to close the nxTCon applet.

Repeat the steps under “Disable” UAC, except in step 5 set the slider back to where it was.

Reboot when finished.